bumper skin removal - drilling holes for PDC retrofit

[Belix]

Steve, you must have removed bumper skins a couple times, any difficulties?
Do you recall seeing any markings showing positioning of PDC holes on bumper skins without PDC holes? Might also be fitting the whole park assist package...but wiating for sensors and park assist modules, then will need to work out wiring.

[Snoopy]

Not the Parking sensors but i thought this maybe of some use to you.

Remove radiator grille



Remove front bumper cover



–   Remove bolts -4-.
–   Remove bolts -2- (pointing upwards) on left and right of wheel housing.
–   Remove bolts -3- from wheel housing.
–   Remove bolts -5- and -6- from underneath.
Further removal is only possible with the help of a second mechanic.
–   Pull front bumper cover -1- out of fasteners of guides on left and right of wing -arrows a-.
–   With the aid of a second mechanic, pull off front bumper cover -1- parallel -arrows b- from vehicle.
–   Disconnect connectors from all electrical components.

Notes and work sequence for parking aid are located in → Electrical system; Rep. Gr.94
Instructions and work specifications for the Park Assist system can be found in → Electrical system; Rep. Gr.94
–   Disconnect washer fluid hose connectors (if fitted) → Electrical system; Rep. Gr.92

[Belix]

sure that will help, thanks! Will just take then off and have a look.
Got any similar diagrams for the rear bumper?

[Snoopy]

I don't sorry it was something sent to me. But others may do as im told its from ElsaWin.